How To Clean Your Carpet At Home - Our Carpet Care Tips

The carpet remains a welcome piece of furniture, despite the abundance of a variety of moderns floors coverings. It is pleasant to walk on the carpet barefoot, children like to play on it, in the end – carpets just make the room cozier. One drawback – any carpet gets dirty quickly, and requires regular and thorough maintenance.

 

In our article, we share tips on how to quickly and effectively clean the carpet at home, as well as get rid of various stains and unpleasant odors with your own hands.

 

How to properly care for carpets in the home

Prevention is always better than cure, so the simplest tip for keeping clean is to take timely care of the carpet’s protection from stains and wear. Our simple recommendations will help prevent damage to the carpet and keep it looking for a long time.

 

  • Very hot water is contraindicated for carpets.
  • When cleaning the carpet yourself, avoid rubbing it against the lint.
  • Do not wet clean the carpet too often – once every 3 months is enough to keep it clean.
  • It is better to remove stains immediately, not allowing them to eat deep into the carpet.
  • Do not place rug on wet floors.
  • Change the position of the carpet from time to time to avoid grease and scuffs in the most traffic able area.
  • Be sure to place pieces of rubber under the legs of heavy furniture to reduce deformation of the flooring.
  • High indoor humidity is detrimental to the structure and appearance of the carpet.
  • The carpet must be vacuumed at least once a week.
  • Deep clean your carpet at least once a year.
  • In winter, it is useful to beat off the carpet in the snow. Cold, like heat treatment, destroys microorganisms and bacteria.
  • You should not lay light carpets in high traffic areas – they are better used for decoration in less walk-through rooms.
  • Well, if a nuisance does occur, read our instructions on how to get rid of stains and unpleasant odors from carpet at home.

 

Carpet cleaning with Vanish

There are many household carpets cleaning chemicals available. Perhaps the most popular of them is the well-known Vanish. Despite the versatility declared by the manufacturer, this tool is not suitable for all types of coatings and sometimes it is better to refuse its use. Let’s take a look at how to use Vanish without harming your carpet.

 

There are several types of Vanish shampoos: antibacterial, anti-odor shampoo, stain remover, and even bleach shampoo for light carpets.

 

Firstly, all of these cleaning products are only suitable for synthetic products, since carpets made of synthetic threads are resistant to abrasion and fading. And carpets made of natural wool or silk under the influence of chemistry can deform, wipe off or discolor. This applies not only to Vanish, but to all households carpets cleaning products: Flash, Mitex, Amway, SunLux. They are not suitable for carpets made of silk, wool, brocade or suede.

 

Secondly, all household detergents are designed to quickly clean fresh, just formed stains.

 

Finally, the third and very important remark: only foam is used for cleaning carpets, and not the liquid itself. To use Vanish and other household chemicals without harm to the carpet, it must be used correctly, without disregarding the manufacturer’s recommendations.

 

Correct use of Vanish for carpet cleaning at home:

  1. Before cleaning with shampoo, the carpet must be vacuumed or shaken out to remove fine debris and dust from it.
  2. Prepare Vanish solution. Too concentrated composition would harm the carpet, and a weak solution will not cope with dirt. Therefore, the correct ratio for Vanish preparation is 1:9 (1 cap of detergent for 9 caps of water). The water temperature should be no higher than 40 °C.
  3. Whisk the solution until thick foam. To do this, just shake it up with a sponge.
  4. Using a brush or sponge, apply the lather to the carpet surface and rub in a circular motion.
  5. If it is necessary to remove the stain, you can apply a local treatment of the dirty area. But to avoid streaks on the surface of the coating, it is recommended to clean the entire product.
  6. After processing, leave the product to act on dirt for 2-3 hours. When the carpet is completely dry, vacuum it to collect any remaining cleaning agent.

Note! Never use dish washing detergents or detergents on carpets. Some ingredients in dish washing detergent is not suitable for textiles, just as carpet shampoos themselves is not suitable for cleaning dishes. Remember, each cleaning agent has its own purpose, and therefore, the corresponding composition. Do not use household chemicals for cleaning what it is not intended for!

 

 

Classy Carpet and Rug Cleaning offers the cleaning of all types of rugs such as Oriental or Persian rugs, wool rugs cleaning, modern rugs cleaning, Shaggy rugs washing, Kilim rugs maintenance, silk rugs maintenance and carpet washing long hairs. Depending on the materials, it is better to opt for professional cleaning in order not to damage the carpets.

Call us today: (925) 621-0103

Continue reading about “Wet Cleaning of Carpet

carpet cleaner at home
Get a Free Quote